Residual Heat Blackening / Fasteners

Application · Fasteners

Bolts out of the tempering furnace, black in 30 to 60 seconds.

On a mesh-belt or continuous furnace, fasteners come out hot and go straight to the quench or the tempering section. RHB takes that same heat and turns it into the black film. One pass, no second heat cycle, no caustic blackening tank at the end of the line.

Where the money goes

Fastener lines run on cents per thousand pieces

At fastener volumes, a process step is not a line item — it is a throughput limiter. Every extra station adds handling, floor space, headcount and a queue. The conventional route adds four of them after the furnace: preheat, caustic blackening, rinse, dry.

RHB keeps one. Parts leave the tempering section, dip, drain, cure. The step you cannot remove is curing, and its temperature requirement is what decides between the two grades.

What decides the grade

Two questions, in this order

  • Does the drawing carry a salt spray clause? If yes, RHB-3270 and an oven that holds 180–200 °C.
  • If no clause, RHB-500 cures from 80 °C and takes parts up to 560 °C.
  • What is your part temperature at the bath? Below 200 °C, neither grade will work.
On a fastener lineConventional hot black oxideRHB
Stations added after the furnace4 (preheat, blacken, rinse, dry)2 (dip, cure)
Bath operating temperature≈140 °C caustic40–60 °C
Acid pickle upstreamTypicalNot used
Hydrogen embrittlement routeOpen via picklingNo acid, no electrolysis
Thread fill riskConversion coating, sub-micron scaleThin film, measured on your parts
Spent bath handlingHot caustic effluentNear-neutral

Thread fit and film thickness are validated on your own parts during the trial. We do not quote a film thickness before measuring one.

Common objection

"Our furnace discharges into a quench, not onto a belt."

Then the part is cold by the time it reaches you, and RHB is not your process. This is the single most common reason a trial fails, and it is decided by plant layout rather than by chemistry. Bring us in after the tempering stage and it works. Bring us in after the quench tank and it does not.

If your line has a tempering oven downstream of hardening, that is the take-off point. If the only hot parts in the plant are at the hardening furnace, the economics change and we will say so.

Next step

Send the part number and the drawing clause

We need the part temperature at the take-off point, the curing temperature your line can hold, and any salt spray requirement on the drawing. A 1 L sample follows, which makes about 11 L of working bath.